0
Getting Started
Operations
Troubleshooting
ENGLISH
Bi-Amp Connections
When using speakers that have input terminals for both woofer units and tweeter units, this
connection outputs one input signal from the two amps on the main unit to each of these units.
With this connection the interference between signals for the woofer unit and tweeter unit is
eliminated so that you can enjoy high quality sound in playback.
• Bi-Amp output is setup using the following combination of channels. The input terminals to be used are
as follows.
·
and
input terminal :
channels
·
and
input terminal :
channels
·
and
input terminal :
channels
·
and
input terminal :
channels
·
and
input terminal :
channels
• Set each switch as shown below.
q
Set the
Operation mode select switch
to “Bi-AMP” (
v
page 6).
w
Set the
Input select switch
according to the input (
v
page 6).
· For RCA input ·········· Set to “RCA”.
· For XLR input ·········· Set to “XLR”.
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
SPEAKERS
XLR
RCA
HIGH
LOW
w
q
w
q
"6%*0
065
13&
13&
065
Example: Bi-Amp connection using
and
channels
b
Setup each pair channel using the same steps.
NOTE
• The same signal is output to channel
and channel
.
• No signal is output from the speaker B terminal.
• Use speakers with an impedance of 4 ~ 16 Ω
/ohms
.
Connections and Settings
NOTE
The input terminal (channel
in case of
and
) that is not used for this setting becomes invalid
regardless of the status of
Input select switch
.
Input select switch
Operation mode select switch
1.POA-A1HDE2_ENG.indd 14
2008/01/18 11:34:46
