PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC
The procedure after replacing the u-COM (Microprocessor), flash ROM, etc. is as follows.
PWB Name Ref. No.
Description
After
replaced
Remark
MAIN
IC214
STM32F103ZG
B
SOFTWARE: SYSTEM
MAIN
IC206
EPCQ16SI8N
s
A
SOFTWARE: FPGA
MAIN
IC102
MX25L4006EM2I
B
SOFTWARE: DSP
After replacing
A
: The software has been written. The software is not written at the time of replacement.
B
: The software has been written. The software may need to be rewritten by version updates. Check the version.
C
: The software has not been written. The software needs to be written after replacement. See “Firmware
UpdateProcedure” for information on writing the software.
D
: The software has been written. Be sure to rewrite with the latest software for your service region. See “Firmware Update
Procedure” for information on writing the software.
25
Содержание PMA-50
