3
●
Before turning the power switch on
Check once again that all connections are correct and that there
are no problems with the connection cables.
●
Power is supplied to some of the circuitry even when the unit is
set to the standby mode. When travelling or leaving home for
long periods of time, be sure to unplug the power cord from the
power outlet.
●
Sufficiently ventilate the place of installation
If the unit is left in a room full of the smoke from cigarettes, etc.,
for long periods of time, the surface of the optical pickup could
get dirty, in which case it will not be able to read the signals
properly.
●
About condensation
If there is a major difference in temperature between the inside
of the unit and the surroundings, condensation (dew) may form
on the operating parts inside the unit, causing the unit not to
operate properly.
If this happens, let the unit sit for an hour or two with the power
turned off and wait until there is little difference in temperature
before using the unit.
●
Cautions on using mobile phones
Using a mobile phone near this unit may result in noise. If so,
move the mobile phone away from this unit when it is in use.
●
Moving the unit
Turn off the power and unplug the power cord from the power
outlet.
Next, disconnect the connection cables to other system units
before moving the unit.
●
Note that the illustrations in these instructions may differ from
the actual unit for explanation purposes.
Moisture condensation may occur inside the unit when it is
moved from a cold place to a warm place, or after heating a cold
room or under conditions of high humidity. Do not use the unit at
least for 2 hours until its inside is dry.
• Do not handle the AC cord with wet hands.
• Do not pull on the AC cord when disconnecting it from AC wall
outlet. Grasp it by the plug.
• If, by accident, water is spilled on this unit, unplug the AC cord
immediately and take the unit to our authorised service centre
for servicing.
Pay attention to the following before using this unit:
●
Moving the unit.
To prevent short-circuits or damaged wires in the connection
cables, always unplug the power supply cord and disconnect the
connection cables between all other audio components when
moving the unit.
●
Store the owner’s manual in a safe place.
After reading the owner’s manual, store them in a safe place as
they could come in handy in the future.
●
Whenever <ON/STANDBY> is in the STANDBY state, the unit
is still connected to AC line voltage.
Please be sure to press
or unplug the cord when you leave home for, say, a vacation.
●
Note that the illustrations in these instructions may differ
from the actual unit for explanation purposes.
The serial number of this product may be found on the back of
the unit. No others have the same serial number as yours. You
should record the number and other vital information here and
retain this book as a permanent record of your purchase to aid
identification in case of theft.
Unauthorised copying, broadcasting, public performance and
lending of discs are prohibited.
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorised
by Macrovision, and is intended for home and other limited
viewing uses only unless otherwise authorised by Macrovision.
Reverse engineering or disassembly is prohibited.
Cautions on Handling
SD CARD
Advanced AL24
VIDEO NR
OFF
ON
ON / STANDBY
HDMI
RESOLUTION
VIDEO NOISE
REDUCTION
BLU-RAY DISC PLAYER
DVD-3800BD
10 cm or more
Wall
Dew Warning
Avoid the Hazards of Electrical Shock and Fire
Before Using
Date of Purchase
Dealer Purchase from
Dealer Address
Dealer Phone No.
Model No.
Serial No.
About Copyright
U. S. Patent No’s, 6,836,549; 6,381,747; 7,050,698;
6,516,132; and 5,583,936.
Supplied Accessories
Please check to make sure the following items are included with
the main unit in the carton.
remote control (RC-1091)
“R6P” (AA) batteries x2
AC cord
owner’s manual
service station list
RCA audio cable
RCA video cable
E5J00_02_04ED_V2_EN.book Page 3 Thursday, October 16, 2008 12:00 PM
