6
Setup
Items not listed under
Introduction
>
Box Contents
are sold separately.
To set up DN-508MXA with your sound system:
1.
If you are using any audio source with RCA outputs (Blu-ray
®
players, stereos, etc.), use standard RCA
cables to connect them to the
ST inputs
on the rear panel. Your audio sources must be line-level (no
phono-level turntables).
2.
If you are using an amplifier or other audio source with outputs that can be wired into standard
Euroblock connectors, connect them to the
Mic
/
Line Inputs
on the rear panel.
3.
Use the included 5-pin Euroblock with jumper wires to connect
Line Outputs
1–4 to
Amp Inputs
1–4.
Each group of 5 connections corresponds to 2 zones. Each zone has a hot (
H
) and cold (
C
) connector,
and each pair of zones shares the ground (
G
) connector.
4.
Use standard Euroblock connectors to connect the loudspeakers of your different zones to the
Speaker Outputs
on the rear panel. For LoZ speakers at 4 Ohm or 8 Ohm, each group of 2
connections corresponds to 1 zone, for 4 total output zones. For HiZ speakers at 70 V, 100 V, or BTL,
each pair of groups of 2 connections corresponds to 1 zone, for 2 total zones. Each zone has a positive
(
+
) and negative (
-
) connector. Always make sure to properly align the wiring polarities between your
speakers and DN-508MXA.
5.
To manage DN-508MXA using its web interface,
connect the
Ethernet Port
and your computer to a
network switch or router using standard Ethernet cables. If your computer is wirelessly connected to
your router, connect just DN-508MXA to that router. Alternatively, connect DN-508MXA’s
Ethernet Port
directly to a computer using an Ethernet crossover cable.
6.
To manage DN-508MXA using serial communication,
connect the
remote port
to your computer
using a 9-pin D-Sub cable. Use a third-party utility to manage DN-508MXA. Alternatively, connect the
RS-422
port to a third-party utility using a standard analog telephone cable with RJ45 connectors.
Tip:
We recommend using the web interface to control DN-508MXA rather than serial communication. It
is much easier to use the web interface via IP communication than a third-party utility via RS-232 serial
communication.
7.
Use the included power cable to connect DN-508MXA to a power outlet.
8.
Power on all of your audio sources (Blu-ray
®
players, stereos, microphones, amplifiers, etc.).
9.
Power on DN-508MXA.
Example:
Zone 1
Zone 2
Zone 3
Zone 4
Computer
To Zone Speakers
Blu-ray Player
Amplifier
Router
Microphones
Power
Jumper Wires
(Connects Line
Outputs 1–4 to
Amp Inputs 1–4)
Содержание DN-508MXA
Страница 2: ......
Страница 56: ...denonpro com Quickstart Guide Version 1 1 ...
