Others
16
ENGLISH
ENGLISH
¢
Audio performance
No. channels:
2 channels
Frequency response:
2 Hz ~ 20 kHz
Dynamic range:
100 dB
S/N:
105 dB
Harmonic distortion:
0.005 % (1 kHz)
Separation:
95 dB
Wow & flutter:
Below measurable limits (± 0.001 % W. peak)
Analog audio output:
Output level : 2.0 Vrms (LINE OUT)
¢
Usable discs:
Compact Disc
Diameter:
120 mm/80mm
¢
Signal format
Sampling frequency:
44.1 kHz
Quantization bit:
16-bit linear/channel
Transfer bit rate:
4.3218 Mb/seconds
¢
Digital output signal format
Format:
Digital audio interface
Optical output:
–15 ~ –21 dBm
Emission wavelength:
660 nm
¢
Pickup
Type:
Objective lens drive type pickup
Objective lens drive type:
Secondary parallel drive
Light source:
Semiconductor laser
Wavelength:
780 nm
¢
General
Power supply:
AC 230 V, 50 Hz
Power consumption:
15 W
Standby : 0.1 W or less
Maximum external dimensions:
250 (W) x 78 (H) x 250 (D) mm (Not including protruding parts)
250 (W) x 82 (H) x 260 (D) mm (Including protruding parts)
Mass:
2.9 kg
* For purposes of improvement, specifications and design are subject to change without notice.
Specifications
If a problem should arise, first check the following:
1. Are the connections correct ?
2. Have you operated the player according to the Operating Instructions ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
Page
Measures
Cause
Symptom
Display does not light and
no sound is produced
when power is turned on.
• Power supply cord is not plugged
into power outlet.
• Plug the power supply cord into the
power outlet.
6
“00 m 00 s” is shown on
the display even though a
CD is loaded.
• The disc is not properly loaded.
• Reload the disc.
2
Disc is not played when
1
/
3
button is pressed.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or replace
the disc.
6
–
No sound is produced or
sound is distorted.
• Incomplete connections with the
various devices.
• The receiver’s function setting or
adjustments are not right.
• Check the connections.
• Check the receiver’s function and
controls and adjust as necessary.
Specific section of the
disc cannot be played
properly.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or replace
the disc.
3
Programmed playback is
not possible.
• The tracks have not been
programmed properly.
• You are playing a disc containing files
in MP3 or WMA format.
• Program properly.
• Programmed playback is not
possible with containing files in MP3
or WMA format.
8
–
A CD-R or CD-RW disc
cannot be played.
• The disc has not been finalized.
• The recording conditions are bad or
the quality of the disc itself it poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
2
–
“Not Support” is
displayed when playing
riles recorded in MP3 or
WMA format.
• You have selected a copyright-
protected WMA file or a file that
cannot be played normally.
• Use the
8
/
6
or
7
/
9
button on the main unit (the
8
or
9
button on the remote control
unit) to select a different file.
11, 12
3
Troubleshooting
Others
