1
Press
CH SELECT/ENTER
.
2
Press
ui
or
CH SELECT/ENTER
to select “Fader”.
3
Use
o
p
to adjust the volume of the speakers.
(
o
: front,
p
: rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.
Fader Function
This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1
Press
CH SELECT/ENTER
.
Channel Volume
FL 0.0dB
SR 0.0dB
C 0.0dB SBR 0.0dB
FR 0.0dB SBL 0.0dB
SW 0.0dB SL 0.0dB
Fader
FRONT : REAR
2
Use
ui
or
CH SELECT/ENTER
to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use
o
p
to adjust the volume.
b
In the case of a subwoofer, reducing the volume when it is at “–12
dB” will change the setting to “OFF” (none).
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
NOTE
When the input source is “iPod”, you cannot perform channel level
setting.
Getting
Started
Connections
Setup
Playback
Remote
Control
Multi-zone
Information
Troubleshooting
ENGLISH
Specifications
Quick Select Function
With this function, the currently playing input source, input mode,
surround mode, MultEQ XT settings and volume can be stored in
the memory.
1
Set the input source, surround mode, MultEQ XT,
Dynamic EQ, Dynamic Volume, Front Speaker
settings and volume to the conditions you want to
store.
2
Press and hold the desired
QUICK SELECT
until
“Memory” appears on the display.
The current settings will be memorized.
• To call out the settings, press
QUICK SELECT
at which the desired
settings were stored.
• The Quick Select name can be changed (
v
page 33).
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at menu “Manual Setup” – “Option Setup” –
“Source Delete” (
v
page 32). In this case, store them again.
Input Source
Volume
Quick Select 1
DVD
–40 dB
Quick Select 2
TV/CBL
–40 dB
Quick Select 3
VCR
–40 dB
[Quick Select Defaults]
Personal Memory Plus Function
This function sets the settings (input mode, surround mode,
HDMI output mode, MultEQ XT, Dynamic EQ, Dynamic Volume,
audio delay etc.) last selected for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone settings and the volumes of the
different speakers are stored for the individual surround modes.
Last Function Memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to
their default values.
1
Turn off the power using
<POWER>
.
2
Press
<POWER>
while simultaneously pressing
<STANDARD>
and
<DSP SIMULATION>
.
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
