ENGLISH
26
Setting the Auto Surround Mode
For the three kinds of input signals as shown below, the surround mode played the last is stored in the memory. At next time it the same signal
inputs, the memorized surround mode is automatically selected and the signal is played.
Note that the surround mode setting is also stored separately for the different input function.
SIGNAL
Default Auto Surround Mode
q
Analog and PCM 2-channel signals
STEREO
w
2-channel signals of Dolby Digital, DTS or other multichannel format
Dolby PL
II
Cinema
e
Multichannel signals of Dolby Digital, DTS or other multichannel format
Dolby or DTS Surround
1
Use the
(left) and
(right) buttons to select the Auto Surround mode.
18 AUTOSURR. ON
OFF
ON
(left) button
(right) button
Press the ENTER or
(down) button to switch the Ext. In SW Level setting.
(Initial)
Setting the Ext. In SW Level
Set the playback level of the analog input signal connected to the Ext. In terminal.
1
Use the
(left) and
(right) buttons to select the Ext. In Subwoofer channel Level playback.
19 EXT.IN SW +15
+00
+05
+10
+15
(left) button
(right) button
Press the ENTER or
(down) button if you want to start the settings over from the beginning.
(Initial)
• Select according to the specifications of the player being used. Also refer to the player’s operating instructions.
• +15dB (default) recommended. (0, +5, 10 and +15 can be selected.)
After setting up the system
1
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other components
or speakers are connected to or the speaker layout is changed.
