Dennis S500 PLUS, Инструкция по эксплуатации

Страница: 12 / 22

12
S500 Plus SP20003_REV_1
Routine Maintenance
CLUTCH CABLE ADJUSTMENT
Over time the cables that operate the drive will need adjusting. This
adjustment can be done at the
“Handle Bar” or at the “Chassis” .
To set at “Handle Bar”
• Remove rubber cover from lever.
• Slacken lock nuts on cable [10mm and 7/16” spanner]
• Adjust cable to desired tension.
• When set, tighten the lock nuts.
To set at “Chassis”
• Slacken 2-off lock nuts on relevant cable [2-off 13mm spanners]
• Adjust cable to desired tension.
• When set, tighten the lock nuts.
ENSURE THE LOCK NUTS ARE TIGHT AND SECURE AND CHECK OPERATION IS
SATISFACTORY BEFORE REPLACING THE CLUTCH COVER AND SCREWS.
NOTE
Storage
The machine should always be kept in a clean dry place, free from condensation. After use ensure that the machine is
thoroughly clean, dry and free from grass and mud.
Under no circumstances must the machine be steam cleaned as this may remove grease from the pre packed bearings.
Because of the nature of lead free petrol we recomend that if the machine is being left unused for more than 2 weeks the
carburetor is run dry. Allow the engine to run out of fuel with the fuel tap switched off.
General Lubrication
REEL
(1-Month)
A grease point is located under the belt guard on the side plate of the machine. This is
to lubricate the internal spur gear that provides drive to the reel. Apply one pump
of grease. Do not over grease.