Dennis E-SERIES ES-34R, Инструкция по эксплуатации

Страница: 22 / 46

22
SP20058_REV0.4
15. GENERAL LUBRICATION
DECK HEIGHT ADJUSTERS
(2-months)
Apply a small quantity of copper grease or similar to the adjuster rods to prevent corrosion and ease adjustment.
REAR ROLLER CHAIN
(1-month)
Apply a small amount of grease.
WHEEL BEARINGS
(1-months)
Two grease points on the bolts that hold the wheel axle. Apply one pump of grease to each.
HEIGHT OF CUT STAINLESS SHAFT
(6-months)
Apply a small amount of grease through the grease nipple. NOTE: To access this grease point you will need to remove the right
hand side guard.
16. STORAGE
The machine should always be kept in a clean dry place, free from condensation. After use ensure that the machine is thoroughly
clean, dry and free from grass and mud. Before off season storage smear a thin layer of grease on to the cutter blades and the
shear blade.
Under no circumstances must the machine be steam cleaned as this may remove grease from the pre packed bearings and
damage electrical components.
If stored for more than a month disconnect battery connector located under the battery cover.