User Manual
bio.x T700 160416
Page 8 of 15
Issued 10/2010
5. Control panel
5.1 Function indicators on the display.
Function Indicator
Warming-up process
Display '41' flashing, LED heater on
Rising horizontal bars
Operating temperature reached,
Heater off
Display '41', LED heater off
Operating temperature reached,
heater on
Display '41', LED heater on
Excess temperature
Temperature indicator flashing
when T>41°C
Energy saving mode
Display '30'
Controllable pump run time
Display ‘xx’, remaining run time is displayed with 5, 10, 15 minutes run time
Error messages,
see section 6.2 (Error messages)
Display ‘LO’; F1 to F8
6. Operation
-
During the cleaning process with the Vario nozzle (17), the hood should be closed, otherwise you
must wear the appropriate protective clothing (protective goggles)!
-
If you are working with a brush, you may also clean with the hood open.
-
Place the parts to be cleaned in the Parts Cleaning Unit.
-
The maximum admissible load may not be exceeded.
-
Connect the Vario nozzle or the cleaning brush with the high-speed coupling to the cleaning hose.
-
Close the cover.
-
If necessary turn on the light with the on/off switch (9).
-
You can also switch on/off (30) the demister unit of the transparent hood.
-
Reach for the cleaning equipment through the gauntlets. Depending on the type of dirt the vario nozzle can be
adjusted from point to surface jet and by moving forward or back to low density.
-
By pressing the foot switch you turn on the feed pump and you can start cleaning.
-
After you have finished cleaning press the foot switch again to turn off the feed pump. The water pump
automatically switches off after about 60 minutes.
-
The Parts Cleaning Unit can also be switched on and off by pressing the multi-control button on the control panel.
-
Take out the cleaned parts.
Note:
When interrupting work, switch off the water pump only and do not disconnect the unit from the mains, so the
detergent remains warm. The micro-organisms in the detergent require heat and oxygen to degrade the oil and
grease. For this reason, the heating system maintains the temperature of the detergent at 41º C and an aerator
ensures oxygen is permanently fed to the micro-organisms. If the unit is switched off, or it breaks down for a long
period of time, the micro-organisms become inactive.
Multi-control button
Display
LED heater
