Demtech Pro-Tester SE, Руководство оператора

Страница: 9 / 20

Rev. B, October 2020
Pro-Tester SE Operator’s Manual Page 6
b.
The system LCD should light up, go through a self-diagnostic test and then prompt the
user to press ENTER to initiate the initialization/calibration sequence. Press ENTER
to perform the initialization/calibration procedure. For the proper operation of the Pro-
Tester
TM do not HALT or skip the procedure.
c.
The system will first move the grip head in (left) to find the home position, then out
(right) to calibrate travel speed. After a short pause the grip will then move back in
(left) and stop at the A or B grip separation position depending on which is selected on
the Control Panel. This procedure verifies the Pro-Tester
TM is in good working
condition. If the system performs as described, you are now ready to operate the system.
If the system does not perform any of the functions described above please contact
DEMTECH Services, Inc.
Figure 5.1
M002
Power Cord
With IEC 60320
Connector
(P/N T-111)
Fuse
Holder
Power
ON/OFF
Switch