Demco PHOENIX ML44, Инструкция по эксплуатации

Страница: 8 / 26

Tools Required
Philips head screwdriver
4mm Allen wrench
14mm wrench or adjustable wrench
Roll Kit Contents
(1) Dispensing Bar with tensioner
(2) Dispensing bar Support brackets
(1) Idler bar with 4mm allen screws
IMPORTANT! - Unplug you laminator
before installing the Phoenix Roll Kit
Remove the side panels
Lower the rollers to the closed or zero position.
Remove the roller gap control knob by taking off the
center cover of the Control Knob and unsrewing the
philips screw in the middle of the Control Knob (Figure 1)
and side panels gently and angle from the back
as the control panel will be attached to the circuit board
on the side frame (Figure 2).
Install Idler Bar (Figure 3)
Locate the pre-drilled holes in the sideframe in back of
the rollers. Attach the idler roll threading the 4mm
bolt through the hole in the side frame and tighten
with the corresponding nut. Repeat on the other side.
Install Roll holder (Figure 4)
Remove the upper back panel. Install roll
holder brackets with the 3 phillips screws.
Mount the roll holder in the bracket.
Replace the side panels and Control Knob.
Instructions for running cold films on Page 13
R
OLL
K
IT
A
SSEMBLY
(O
PTIONAL
)
PHOENIX
44 LAMINATOR
7
Figure 1
Figure 2
Figure 3
Figure 4