11. Drill 7/16” hole on each side into bottom of bumper
using baseplate as a template .
13. Reinstall Styrofoam back on bumper, fascia and all hard-
ware except where noted. If equipped with fog and/or side
marker lights be sure to plug them back in. NOTE: check
headlights for proper adjustment.
14. Plug mount (item #11) may be installed if desired in
convenience holes on either chain anchor or as desired.
NOTE: Excess material may be trimmed from bracket.
12. Cut bumper as shown to allow the nut and washers
to be placed inside the bumper. Install 7/16”” x 3 1/2”
bolt, and 7/16” flat washer through the baseplate and
into the bumper with the 7/16” flat washer, 7/16” lock
washer, and 7/16” nut
.
Use blue on bolts
and tighten all bolts according to chart on front page.
R
10. With an assistant install baseplate with bumper over
top of baseplate onto vehicle using eight 8mm x 1.25mm
x 30 mm bolts, 8 mm fender washer and 8mm lock wash-
ers. Use blue
on all bolts and tighten all
bolts according to chart on front page.
R
Find more Demco products on our website.
Find out more trailer hitches and towing we have.
