Demco BASE PLATE Скачать руководство пользователя страница 3

Страница: 3 / 4

7. Remove four bolts on each side from bumper and set

bumper aside. NOTE: These bolts will not be reused.

4. Remove 1 plastic push fastener from inside fender on

each side.

9. Remove temp sensor from bracket and replace in the back

of the mount.

6. Remove Styrofoam from front of bumper and set aside.

5. Pull on the outer corner of the facia outward and down

to Remove Facia. Unplug fog lights if equipped.

8. Trim air deflector as shown to allow crossmember to fit in

front.

3. Remove 3 plastic push fastener from behind the front

facia.

Содержание BASE PLATE

Страница 1: ...the Best BOlT TORQuE sPECifiCaTiONs size grade Torque 5 16 5 20 ft lbs 3 8 5 35 ft lbs 7 16 5 56 ft lbs 1 2 5 85 ft lbs size Torque 8mm 22 ft lbs 10mm 42 ft lbs 12mm 70 ft lbs 14mm 95 ft lbs sTaNDaRD...

Страница 2: ...re they have read and understand the proper operating procedure DO NOT use worn or damaged cables and or pins Be sure the SAFETY CABLES are hooked chassis to chassis to both the towing and towed vehic...

Страница 3: ...side 9 Remove temp sensor from bracket and replace in the back of the mount 6 Remove Styrofoam from front of bumper and set aside 5 Pull on the outer corner of the facia outward and down to Remove Fa...

Страница 4: ...et 12 Cut bumper as shown to allow the nut and washers to be placed inside the bumper Install 7 16 x 3 1 2 bolt and 7 16 flat washer through the baseplate and into the bumper with the 7 16 flat washer...