43
Wiring the Tractor
Roll-Rite Tractor Wiring Instructions
There are two items to wire on the tractor before you can operate your
Demco side dump. The control box and the tarp power wire.
To install the control box, find a suitable location in the cab of the
tractor and mount the control box. The red and black two wire cable
attached to the back of the box is the power wire. Plug the cigarette
lighter end into a power connection in the cab.
[If you do not have an available outlet for the cigarette lighter
end, use the following instructions:
Cut the cigarette lighter plug
off. Split apart the wires and connect the red wire to a 12v dc power
source and the black to ground.
Red wire must be positive and Black
negative. Reversing these wires can damage the control system.
A bag of
terminals is included to allow you to tap into most truck fuse panels.]
Route the gray cord and male 9 pole plug out of the cab and to the
front bulkhead of the side dump. Plug the cord into the female 9 pole
socket on the trailer bulkhead. You will now be able to raise and lower
the rear axle and dump the tub.
(
NOTE
: Air must be supplied to the side dump for the lift axle to
operate properly. Hydraulic oil must be supplied to the side dump to
dump the tub.)
To use the tarp you will need to supply 12 volt power to the side dump
to operate the tarp motor. Due to the large power draw of the tarp
motor, the electrical supply must be hooked directly to the battery and
the heavy #6 wire included with the kit must be used.
Refer to the Roll Rite wiring diagram for reference. The relay has been
already mounted on the side dump and the momentary switch that
rolls/unrolls the tarp is in the control box installed previously. All
that needs to be done is to run a wire from the battery to the female two
pole socket on the road side front corner of the side dump.
Locate the circuit breaker as close to the positive battery post as
possible. If the circuit breaker is not mounted to the battery box or
truck frame, make sure that the terminals cannot touch anything that
would create a short circuit. See image on next page for installation
orientation of circuit breaker.
Separate enough of the white wire on the #6 white/black cord to reach
from the positive battery terminal to the circuit breaker. Cut off the
white wire. Strip the white wire and crimp on ring terminals to match
the battery cable bolt and the post on the circuit breaker.
Don’t hook the white wire to the battery until everything else is
wired.
Crimp a ring terminal on the white wire on the remaining white/black
cord and attach it to the circuit breaker.
Crimp a ring terminal on the black wire and attach it to the negative
battery post.
Содержание 9CCRTB14
