I-1205
Rev. B-43816
Page 7 of 13
3/23/2018
Modify Programming
When modifying the programming of the unit. Use the flow chart below for modifications. The menus change slightly
when modifying the programming.
Company Name
Press and hold “Enter” Button for 3 Seconds until backlight comes on
Press
Language
English, Spanish, French, Portuguese
Press
Rack Count
Show Rack count
Press
Det. SP Input
Det. C = Concentration or P = Probeless SP= Set point Input & probe reading
Press
Modify Program
Enter Code
When Concentration is chosen
When Probeless Door is
chosen
When Probeless Conveyor is
chosen
Concentration Set Point
0-1000
Recharge Time
1s – 5 min
Recharge Time
1s – 5min
Press
Press
Press
Feed Rate
0-10
Dead Cycles
0-5
Dwell Time
1s – 10 min
Press
Press
Press
Feed Limit
5s – 10 min
Initial Charge
1s – 10 min
Initial Charge
1s – 10 min
Press
Press
Press
Alarm Delay
5s - 10 min
Charge Activate
Off-60s
Charge Clock
5 min – 16 hrs
Press
Initial Charge Activate
will
determine the length of the
rinse trigger that instigates an
initial charge while in probe-less
mode.
Charge Clock -
If no triggers are
received for this length of time, the
next wash trigger will give an initial
charge
Alarm Volume
0-10
Press
Rinse Speed
0-100%
Press
Rinse Delay
0-15s
Door Mode Only
Press
Rinse Limit
15s - 30s
Door Mode Only
Press
Rinse Length
5s-75s
Conveyor and Door/Detergent Trigger only Modes
Press
Sanitizer Speed
0-100%
Press
Control Mode
Press Enter, then select using arrows Concentration (Probe) or Probe-less
Press
Machine Type
Press Enter, then select using arrows Conveyor or Door
.
Press
Trigger Mode
Press Enter, then select Detergent/Rinse or Rinse Only or Detergent Only
Press
Company Name
Press Enter, use arrows to change characters, use sanitizer prime and exit to move
cursor left and right.
Press
Rack Count
Press Enter, then Exit to Reset Rack Count
Press
Enter New Code
Enter 4 digit code, use sanitizer prime button to move cursor
Press
Control Mode
Reverts back to beginning of programming
