SEAT ASSEMBLY
LEG HOLD DOWN & SEAT INSTALLATION
ATTACH THE SEAT ASSEMBLY TO THE FRAME (
G
) USING M12 x 76MM BOLT (
O
), M12 FLAT
WASHERS (
S
), AND M12 LOCK NUT (
U
).
(* NOTE THE TIGHTER YOU MAKE THE BOLT, THE
MORE SECURE THE BENCH WILL BE.)
INSERT THE LEG HOLD DOWN
(D)
INTO THE FRAME ASSEMBLY AND SECURE IT WITH THE
PULL PIN.
AT THIS POINT YOU WILL WANT TO MAKE SURE YOUR BENCH IS ON A FLAT SURFACE AND
TIGHTEN THE NUTS ON THE FRONT AND REAR FOOT.
NEXT YOU WILL WANT TO TIGHTEN THE NUTS ON THE SEAT AND BACKREST. THEY NEED TO BE
TIGTHENED ENOUGH TO REMOVE SIDE TO SIDE MOVEMENT, BUT NOT SO TIGHT THAT THE SEAT
AND BACKREST WILL NOT ROTATE.
D
M
Q
Q
S
