NOTE: IF THE BACKREST OR
SEAT ARE LOOSE OR WOBBLE
TIGHTEN THESE NUTS UNTIL
THEY DO NOT MOVE SIDE TO
SIDE.
(NOTE: THE NUTS USED ON THIS BENCH ARE LOCK NUTS, THIS MEANS YOU MUST TIGHTEN THEM DOWN
PAST THE PLASTIC INSERT.) YOU MUST USE A WRENCH TO TIGHTEN!
SEAT & BACKREST INSTALLATION
ATTACH THE THE BACKREST ASSEMBLY AND THE SEAT ASSEMBLY TO THE BODY USING THE M12 x
80MM BOLTS (
J
), M12 FLAT WASHERS(
O
), AND M12 LOCK NUTS (
Q
).
* THE TIGHTER YOU MAKE
THESE BOLTS THE MORE STABLE THE BENCH WILL GET.
(NOTE: THE LOCK PIN FOR THE SEAT IS
NOT NEEDED IN THE FLAT POSITION.)
NEXT ATTACH THE INCLINE SUPPORT (
D
) TO THE BACKREST ASSEMBLY USING THE THE M10 x
115MM BOLT (
K
), M10 FLAT WASHERS (
P
), AND M10 LOCKNUT (
R
). USE THE SEAT SUPPORT PIN
SUPPLIED TO ADJUST THE INCLINE.
MAKE SURE ALL BOLTS ARE BEFORE USE. CHECK THE BOLTS PERIODICALLY AND TIGHTEN AS
NEEDED.
J
K
P
P
O
O
Q
R
D
