4.
With a feeler gage (D) Fig.
36,
measure the gap be
tween the table surface and the straight edge (8) near the
infeed roll (E).
5.
If an adjustment to the infeed roller (E) Fig.
36,
is
necessary, loosen set screw (F) Fig.
37,
located under
neath the left front end of the table.
6.
Turn adjustment collar
(G)
Fig.
37,
left or right as
needed to attain proper height adjustment.
7.
Tighten set screw (F) Fig.
37,
after adjustment is
made.
To check the outfeed roller height setting, proceed as
follows:
1.
With a feeler gage (H) Fig.
38,
measure the gap be
tween the table surface and the straight edge (8) near the
outfeed roller
(J).
2.
If an adjustment to the outfeed roller is necessary,
loosen jam nut
(K)
Fig.
39,
located on the left side of
machine under the table, and turn collar (L) right or left
as needed until the outfeed roller is adjusted properly.
3.
Tighten jam nut
(K)
Fig.
39.
15
Fig.
36
Fig.
37
Fig.
38
Fig.
39
