ADJUSTING
TABLE HEIGHT SCALE
The table height scale is adjusted at the factory and
indicates the distance from the table to the cutting circle
(depth of cut).
To check and adjust the pointer, proceed as follows:
1.
Run a piece of wood part way through the planer and
stop the machine.
2.
Measure the thickness of the finished piece, as shown
in Fig. 33. If necessary, loosen two screws (A) Fig. 34,
adjust pointer (8) and retighten screws (A).
CHECKING AND ADJUSTING
BED ROLL HEIGHT
The height of the bed rolls (A) Fig. 35, should be set
between
.002"
and .004" above the table surface, with
the bed rolls at their lowest position. To check the infeed
bed roiler height setting, proceed as follows:
1
.
MAKE CERTAIN THE MACHINE IS DISCON
NECTED FROM THE POWER SOURCE.
2. Turn height adjustment knob (8) Fig. 35, counter
clockwise as far as it will go.
3. Place a straight edge
(C)
Fig. 35, across the infeed
and outfeed roilers on the left side of the table as shown.
Fig. 33
Fig. 34
Fig. 35
14
