ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SHAPER TO THE POWER SOURCE
UNTIL THE SHAPER IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE
ENTIRE INSTRUCTION MANUAL.
8
Fig. 5
Fig. 6
Fig. 8
Fig. 7
ASSEMBLING SPINDLE
RAISING AND
LOWERING HANDWHEEL
1.
Insert key (A) Fig. 5, into slot in spindle raising and
lowering shaft (B) as shown.
2.
Assemble handwheel (C) Fig. 5, onto spindle shaft
(B), making certain the key (A) fits into the slot (D) in the
handwheel. Insert the set screw which holds the hand-
wheel to the shaft and tighten screw firmly against key.
3.
Thread lock knob (E) Fig. 6, into the spindle shaft (B).
ASSEMBLING EXTENSION WINGS TO SHAPER TABLE
1.
Assemble extension wing (A) Fig. 7, to shaper table (B) using three 1-1/4 inch-long hex head screws (C)
and flat washers (D) supplied. Use a straight edge (E) Fig. 7, to make certain the extension wing is level with
shaper table before tightening three screws (C). Assemble and level remaining extension wing in the same
manner.
2.
Fig. 8, illustrates both extension wings assembled to shaper table.
A
B
C
D
B
E
D
C
A
C
D
B
