Delta HOMECRAFT H26-260L, Инструкция по эксплуатации, Страница: 21 / 76

21
AdjUSTMENTS
BEvEL PIvOT
With the bevel lock knob loosened, the control arm of
the saw should tilt easily from 0° and 45°. If it does not
or if there is play in the pivot, the saw must be repaired
by a HOMECRAFT® AUTHORIZED SERVICE CENTER.
Laser radiation. Avoid direct eye
contact with light source.
LASER GUIdE
Refer to Figure 22.
1. Secure a piece of scrap material to the table
surface using the work clamp or a C-clamp.
2. Plug the saw into the power source and make a
slight cut to score the wood.
3. Release the switch trigger and make sure the blade
comes to a full stop, then raise the saw arm to the
upright position.
4. Unplug the saw. Do not remove the scrap piece.
5. Turn on the laser switch (A). If properly aligned, the
laser should align with the left edge of the partial
cut you just made.
6. If the laser does not align with the left edge of the
cut, loosen the laser adjustment screw (B) using
the Phillips end of the supplied blade wrench and
reposition the laser.
7. Once aligned, tighten the screw using the blade
wrench and recheck alignment of laser line to cut
made in scrap material.
FIGURE 22
1
2
3
4
5
6
7
B
A