Delta DVP-SA2, Инструкция

Страница: 6 / 20

- 5 -
 DC Signal IN – SINK mode
Input point loop equivalent circuit
 DC Signal IN – SOURCE mode
Input point loop equivalent circuit
24G
+24V
S/S
X0
X1
[ Figure 5 ]
+24V
24G
S/S
X0
X1
[ Figure 6 ]

Output Point Wiring
1. DVP-SA2 has two output modules on it, relay and transistor. Be aware of the
connection of shared terminals when wiring output terminals.
2. Relay output terminals, Y0 to Y3 of relay models use C0 common port. See [Figure
7]. When the output points are enabled, their corresponding indicators on the front
panel will be on.
3. Transistor output terminals, Y0 to Y3 of transistor (NPN) models use UP, ZP
common port. See [Figure 8].
4. Isolation circuit: The optical coupler is used to isolate signals between the circuit
inside PLC and input modules.

Relay (R) output circuit wiring

DC power supply

Emergency stop: Uses external switch