Delta 80SF040J24, Инструкция по эксплуатации, Страница: 8 / 24

5
(2) After some function is selected, if there is no “Turn-off” operation or there is no remote
control signal within two minutes, then press this key again to start circular function selection
from previous setting function.. Two minutes later or if there is “Turn-off” operation or there
is a remote control signal, then press this key again to start circular function selection from
the first function..
◆
▲/▼
(1) If there is no function setting, every press of ▲/▼ will increase/decrease setting temperature
by 1°C.The temperature range is 16~30°C.
(2) If there is some function setting, every press of ▲/▼ will switch the options of that function.
( the circulation by the press on the key ▲ and on the key ▼ is reverse).
• Up/Down SWING : There are two options, Swing On and Swing Off.
• Left/Right SWING : There are two options, Swing On and Swing Off.
• BLOW: there are two options, Blow on and Blow off.
• E-HEATER: There are two options, E-heater On, E-heater Off.
• TIMER: It is used to set the timer among 0~24h.Within and over 10h, every press of ▲/▼
will increase or decrease timer by 0.5h and 1h respectively.
• AIR: There are two options, Air On and Air Off (reserved).
• SLEEP: There are two options, Sleep On and Sleep Off.
• TURBO: There are two options, Turbo On and Turbo Off.
• SET: There are two options, Set Temperature On and Set Temperature Off.
• TEMP: there are two options,TEMP On and TEMP Off.
• SAVE: It’s used to set temperature limit under cooling and heating mode. Quit “SAVE”
function by pressing “Function” and “▼” simultaneously.
(3) All functions will be shielded by pressing both ▲ and ▼ simultaneously for five seconds.
After that, “88” LED will display “EE” for five seconds by pressing any other key to tell the
user that the keypad has been locked. Another press will undo the shielding function and go
to the normal status.
◆
Speed
It is available to select the fan speed among auto, low, middle, high circularly by pressing this
key.
2.3.2 Buttons for special functions
(1) Enquiry of the indoor unit address.
Under the “Off” status of the unit, the “88”LED will display the address number of this indoor
unit by pressing the buttons “Speed” and “ON/OFF” simultaneously.
(2) Enquiry of the unit type
Under the “Off” status of the unit, by pressing the buttons “Mode” and “ON/OFF” simultaneously,
for cooling only unit, “COOL” icon will light up on the control panel, while for cooling and heating
unit, “HEAT” icon will light up.