WARNING:This unit weighs 85 pounds. When
mounting overhead, make certain that the unit
is securely fastened and supported.
1.
Locate the four 1” eye-bolts, and the four 1/4-20
flange nuts supplied with the unit.
2. Use a 5/32” Allen wrench to remove the four screws
(C) Fig. 5 from the top of the air cleaner (D).
3. Thread one flange nut on the eyebolt until approxi-
mately 3/4 of the bolt is exposed.
4. Thread an eye-bolt into each of the four holes where
screws (C) were removed in
STEP 2
.
5. Fig. 6 illustrates the four eye bolts attached to the top
of the air cleaner.
NOTE:
Be certain the flange nuts are
tightened against the surface of the air cleaner, and that
the eyebolts extend an equal distance above the top of
the air cleaner.
When suspending the air cleaner from the ceiling or
other overhead support, use steel s-hooks that are a
minimum of 1/4".
NOTE:
Thread all lag hooks at least
1-1/2" into the supporting structural members.
When suspending the air cleaner from the ceiling or
other overhead support, be certain the supporting
hardware (not supplied) is securely anchored.
WARNING: Never secure the air cleaner hard-
ware to drywall, drop ceiling tile/frame, or other
non-structural members.
6
Fig. 5
Fig. 6
MOUNTING THE AIR CLEANER TO THE CEILING OR
OVERHEAD SUPPORT
WARNING: Keep a minimum of seven feet between bottom of air cleaner and the floor surface.
DO NOT use rope, cable, or power cord to suspend the unit from the ceiling. Use a chain rated for a minimum
of a 150 lb. working load. IMPORTANT: When determining a location to mount the unit, the air cleaner will
operate more efficiently when the air flow is unrestricted. Do not locate the unit in a corner or near any heating
or cooling vents.
C
D
CONNECTING MACHINE TO POWER SOURCE
POWER CONNECTIONS
A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be
protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have
3-prong grounding type plugs and 3-hole receptacles which accept the tool’s plug. Before connecting the motor to
the power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same
characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will
damage the motor.
MOTOR SPECIFICATIONS
This machine is wired for 120 volt, 60 HZ alternating current. The no-load speed of the motor is 1075 RPM, and the
full-load amp is 7.9.
D
