For Delta 12” Wood Lathes Only
1.
Thread M8 hex nuts (A) Fig. 9 on M8 x 55mm hex socket set screws (B).
2.
Thread set screws (B) Fig. 9 with hex nuts (A) into the two tapped holes in the
bottom of mounting brackets (D).
NOTE:
To make installation easier, adjust the two
set screws (B) so that tops of screws are equal in length, then tighten hex nuts (A)
against bottom of mounting brackets (D).
3.
Position clamping plates (E) Fig. 10 under mounting brackets (D). Fasten
with M8 x 55mm socket head set screws (F) with
16mm x 41mm
flat washers (F).
Loosely tighten hardware (F) Fig. 10. Remove the tailstock from the machine.
4.
Insert clamping plate (E) Fig. 11 of mounting bracket assembly (D) into
channel (G) on tailstock end of lathe bed.
NOTE:
Loosely-tighten mounting
hardware (F).
5.
Slide the remaining mounting bracket assembly (D) Fig. 12 at the headstock
end of the wood lathe in the same manner.
NOTE:
Position the left side of
mounting bracket assembly (D) Fig. 12 so it is approximately 1" from the end of
the lathe bed (H).
NOTE:
Loosely tighten the mounting hardware.
4
Fig. 11
Fig. 12
Fig. 13
Fig. 14
ATTACHING CARRIAGE TO DUPLICATOR RAIL
1.
Loosen and remove screw (A) Fig. 13 and belt guide (B) from the
RIGHT END
of duplicator rail (C).
2.
Loosen two screws (D) Fig. 14 and raise wiper (E) and retainer plate (F) to their highest position. Tighten two
screws (D). Repeat this procedure on the other side of carriage (G).
3.
Slide carriage (G) Fig. 15 onto duplicator guide rail (C) by inserting two guides (H) into channels (J) and sliding
carriage (G) into gear rack (K). Replace belt guide and screw that were removed in
STEP 1
to the right side of the dupli-
cator rail (C).
D
F
G
E
D
H
A
B
C
G
E
F
D
Fig. 9
Fig. 10
D
A
B
E
F
D
Fig. 15
J
K
C
G
H
Содержание 46-408
Страница 19: ...19 NOTES...