11
CUTTING CURVES
When cutting curves, turn the stock carefully so that the blade will follow without being twisted. If a curve is so abrupt that
repeated new kerfs are needed, use either a narrower blade or one that has more set. The more set a blade has, the easier the
stock is to turn. However, the cut is usually rougher than when using a medium set.
When withdrawing the blade, be careful not to draw the blade off of the wheels. In most cases, it is easier and safer to turn the
workpiece and saw out through waste material. Do not back the blade out while the saw is running.
CHANGING THE BLADES
1.
DISCONNECT TOOL FROM POWER SOURCE.
2. Open the upper and lower wheel guards.
3. Release tension on the saw blade.
4. Loosen the table alignment pin (A) Fig. 28 with a wrench
and pull it out. Remove table insert.
5. Take the blade off the wheel, and guide it through the
slot in the table.
6. Install the new blade by reversing the procedure. (Table
alignment pin should be seated by gently tapping it with a
hammer).
ACCESSORIES
A complete line of accessories is available from your Delta Supplier, Porter-Cable · Delta Factory Service Centers, and Delta
Authorized Service Stations. Please visit our Web Site
www.deltamachinery.com
for a catalog or for the name of your near-
est supplier.
WARNING:
Since accessories other than those offered by Delta have not been tested with this
product, use of such accessories could be hazardous. For safest operation, only Delta recommended
accessories should be used with this product.
PARTS, SERVICE OR WARRANTY ASSISTANCE
All Delta Machines and accessories are manufactured to high quality standards and are serviced by a network of Porter-
Cable · Delta Factory Service Centers and Delta Authorized Service Stations. To obtain additional information regard-
ing your Delta quality product or to obtain parts, service, warranty assistance, or the location of the nearest service
outlet, please call 1-800-223-7278 (In Canada call 1-800-463-3582).
Two Year Limited Warranty
Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which
in normal use has proven to be defective in workmanship or material, provided that the customer returns the product pre-
paid to a Delta factory service center or authorized service station with proof of purchase of the product within two years
and provides Delta with reasonable opportunity to verify the alleged defect by inspection. Delta may require that electric
motors be returned prepaid to a motor manufacturer’s authorized station for inspection and repair or replacement. Delta
will not be responsible for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration
made or specifically authorized by anyone other than an authorized Delta service facility or representative. Under no cir-
cumstances will Delta be liable for incidental or consequential damages resulting from defective products. This warranty
is Delta’s sole warranty and sets forth the customer’s exclusive remedy, with respect to defective products; all other war-
ranties, express or implied, whether of merchantability, fitness for purpose, or otherwise, are expressly disclaimed by Delta.
Printed in U.S.A.
A
Fig. 28