9
Fig. 17
Fig. 18
ASSEMBLING B E LT
A N D PULLEY G U A R D
Assemble belt and pulley guard (A) Fig. 17, to the top of
the stand and surrounding the driven pulley with two
3/4-20 x 5/8
hex head screws, flat washers and hex
nuts (B).
ASSEMBLING SWITCH
1.
M A K E C E R TAIN T H E B A N D S AW IS D I S C O N-
N E C T E D F R O M T H E P O W E R S O U R C E.
2.
CAUTION: T H E O N / O F F SWITCH-TO - M O TO R
CORD (F) FIG. 18, IS TIED TO VERTICAL M O U N T I N G
P O S T (G) O P P O S I T E T H E M O TO R P U L L E Y.THIS
C A B L E TIE (H)P R E V E N T S T H E SWITCH-TO - M O TO R
C O R D (F), FROM C O N TACTING T H E B E LT O R M O TO R
PULLEY DURING O P E R ATION. IMPORTA N T:D O N O T
R E M O V E THIS C A B L E TIE UNLESS Y O U A R E USING
T H E A C C E S S O RY #28-984 HEIGHT A TTA C H M E N T
W I T H T H E B A N D S AW .
3.
Remove two outer hex nuts and lock washers (A)
Fig. 19, from the two screws extending out from the back
of the switch box (B).
4.
Insert two screws (C) Fig. 19, located on back of
switch box, into two holes (D) located in the band saw
arm.
5.
Fasten the switch box (B) to the band saw arm using
two hex nuts and lockwashers (A) Fig. 20, which were re-
moved in STEP 3.
Fig. 19
Fig. 20
B
A
C
D
A
B