9
ASSEMBLY
To reduce the risk of injury, turn unit off and disconnect the machine from power source before installing
and removing accessories, before adjusting and when making repairs.
An accidental start-up can cause injury.
ASSEMBLY TOOLS REQUIRED
T-Handle T30 Torx Wrench
PC5
(Supplied)
See Figure 4.
1.
Attach the cutterhead height adjusting handle
PC3
to the
shaft
B
, aligning the flat edge of the shaft with the
flat edge in the handle.
2.
Fasten the cutterhead height adjusting handle to the
shaft using the M6 x 20mm Torx Head Screw
PC6
and
M6 Split Lock Washer
PC8
with the supplied T-Handle
T30 Torx Wrench
PC5
.
NOTE:
The cutterhead height adjusting handle is supplied with
markings on the dial to make your cuts accurate.
See Figure 3.
1.
Use the supplied T-Handle T30 Torx Wrench
PC5
to
attach the cutterhead lock handle
PC4
to the shaft
A
with the M6 x 20mm Torx Head Screw
PC6
and M6
Split Lock Washer
PC8
.
ATTACHING THE CUTTERHEAD
LOCK HANDLE
FIGURE 3
ATTACHING THE CUTTERHEAD
HEIGHT ADJUSTING HANDLE
FIGURE 4
PC3
PC4
PC6
PC6
PC8
PC8
A
B
