5
ASSEMBLY
LOWERING
EXTENSION TABLES
The infeed and outfeed table extensions (A) Fig. 4, are
shipped attached to the machine and rotated to the
“UP” position. Rotate both table extensions to the down
position as shown. The top surface of the table
extensions should be level with the planer table. To
check and adjust if necessary, refer to the section of this
manual entitled
“LEVELING TABLE EXTENSIONS.”
ASSEMBLING CUTTERHEAD
LOCK HANDLE
1.
Assemble the cutterhead lock handle (A) Fig. 5, to
shaft (B).
2.
Fasten cutterhead lock handle (A) Fig. 6, to the shaft
using the M6 - 20mm special hex socket head screw (C),
with wrench supplied.
Fig. 4
Fig. 5
Fig. 6
Fig. 3
Stand Assembly For Model
22-565
A - Top Brace 17-7/8" (4)
B - Bottom brace 22-1/4" (4)
C - Leg (4)
D - Rubber feet (4)
E - Carriage bolt M8 x 1.25 x 16 (32)
F - Flange nut M8 x 1.25 (36)
* - Hex head flange screw M8 x 1.25 x 35 (4) (For fastening
planer to stand) * not shown
1.
Align the holes in the bottom braces (B) Fig. 3 with
the holes in the legs (C), insert a carriage bolt (E) through
the leg and the bottom brace, and thread the flange nut
(F) onto the carriage bolt. Repeat this process for the
remaining holes in the bottom braces and table legs. Do
not completely tighten hardware at this time.
2.
Assemble the top braces (A) Fig. 3 to the legs (C) in
the same manner as step 1.
3.
Insert the rubber feet (D) Fig. 3 onto the end of the
legs (C) and tighten all hardware at this time.
A
B
C
D
E
F
A
A
A
B
C
A
