Delta OHM HD32.8.16, Руководство пользователя, Страница: 38 / 48

- 38 -
10.1.2 The Erase function: clearing the memory
To clear the memory use the Erase Log function (see par. “4.2.5 Log File Manager”). The
instrument starts clearing the internal memory; at the end of the operation, it goes back to normal
display.
NOTES:
•
Data transfer does not cause the memory to be erased: The operation can be repeated as many
times as required.
•
The stored data remain in the memory independently of the battery charge conditions.
•
In order to print the data to a parallel interface printer, you must use a parallel-serial adaptor (not
supplied).
•
The direct connection between instrument and printer via a USB connector does not work.
•
Some keys are disabled during logging . The following keys are enabled: MEM , SETUP , TIME ,
ENTER and ESC .
10.2 T
HE
P
RINT FUNCTION
Press PRINT to send the measured data directly to the RS232 ports, in real time. The printed data
units of measurements are the same as those used on the display. The function is started by pressing
PRINT . The time interval between two consecutive prints can be set to 0 or from 2 seconds to 1
hour (please see the Print interval menu item in the par. “4.3.2 Print Interval”). If the print interval
is equal to 0, by pressing PRINT a single data is sent to the connected device. If the print interval is
higher than 0, the data transfer continues until the operator stops it by pressing PRINT again. The
“PN” message is displayed at the top of the display.