General Tab
Page 19 of 67
eZV-440 Version 2.1 Application Guide
Document Edition 2.5
Network Settings
This section describes the fields found in the Network Settings section.
Field name
Description
BACnet Address
Displays the current controller’s BACnet address. This field is read-only when the DNA
box is checked. If you want to enter a new address, clear the DNA box.
NFC Password
Displays the password that secures access to the controller’s NFC chip. The value range
is 0 to 65535. The password is stored on the AV96 object.
The Device Password field on the Delta Controls mobile applications must match the
NFC password before any data can be written to the NFC chip.
DNA
Turns on or off Derived Network Addressing (DNA) automatic addressing. DNA is turned
on when the box is checked; the BACnet address also becomes read-only. To manually
enter a new address, clear the DNA box.
Delta Controls products have the option to use DNA or Derived Network Addressing, a
system of organizing and configuring controllers in a network. When DNA is enabled,
addresses are automatically assigned to a device based on the BACnet network type and
the Delta Controls product type, so that a device can work out-of-the-box without much
set up.
For more information about DNA, see Appendix C of the
on the Delta Controls Support web site.
NET1 Protocol
Displays the network protocol currently enabled for the NET1 port. This is a read-only
field.
NET1 Speed
Displays the baud rate for the NET1 port.
Any changes to the baud rate will be applied
immediately
to all Delta Controls
controllers in the network.
NET1 Number
Displays the controller’s BACnet network number.
NET1 MAC Address
Displays the controller’s network address typically set up by the controller’s DIP
switches.
NET2 Protocol
Displays the network protocol currently enabled for the NET2 port. This is a read-only
field.
NET2 Speed
Displays the baud rate for the NET2 port.
Any changes to the baud rate will be applied
immediately
to all Delta Controls
controllers in the network.
