9
SECTION 2: CASE ASSEMBLY
STEP 4
T
V
INSTALL THE BACK PANELS (PART T) USING (14)
BACK PANEL SCREWS (PART V) FOR EACH.
TIGHTEN WITH THE PHILLIPS SCREWDRIVER.
ABOVE ONE BACK PANEL IS SHOWN INSTALLED.
THE SMALL NOTCH IN THE BACK PANEL MUST BE
INSTALLED AS SHOWN AS CAN BE SEEN IN FIGURE
3, THE NOTCH LINES UP WITH A NOTCH IN THE RAIL
PRE-ASSEMBLED TO THE TOP. THIS WILL ALLOW
ATTACHMENT OF THE WALL STRAP - SEE KIT FOR
INSTRUCTIONS ON USE.
