4
SECTION 1: DRAWER ASSEMBLY
STEP 1
FIG. 1
J
C
A or B
F
G
D
1. ATTACH THE LEFT DRAWER SIDE (PART C) TO THE DRAWER FRONT (PART A OR B)
USING (2) DRAWER ASSEMBLY SCREWS (PART J), TIGHTEN WITH THE PHILLIPS
SCREWDRIVER. BE SURE THE GROOVE IN THE BOTTOM OF THE PARTS LINE UP. SEE
FIGURE 1. THE METAL DRAWER GUIDE MUST BE TO THE OUTSIDE. REPEAT WITH THE
RIGHT DRAWER SIDE (PART D)
2. SLIDE THE DRAWER BOTTOM (PART F)
INTO THE GROOVES ON THE DRAWER SIDES,
UNTIL IT IS IN THE GROOVE ON THE DRAWER
FRONT. BE SURE THE NOTCHED CORNERS
ARE TOWARDS THE DRAWER FRONT.
3. INSERT THE DRAWER SUPPORT (PART
G) INTO THE CUTOUT IN THE DRAWER
FRONT. BE SURE THE END OF THE
DRAWER SUPPORT WITH THE
PRE-DRILLED HOLE IS TO THE BACK.
