Digital Projection E-Vision 4000 Series
Installation Precautions
Installation Precautions
The projector must be installed only by suitably qualified personnel, in accordance with local building codes.
The projector is heavy. Use safe handling techniques when lifting the projector.
Do not drop or knock the projector.
Do not install the projector close to anything that might be affected by its operational heat, for instance, polystyrene ceiling tiles, curtains etc.
Place the projector in a dry area away from sources of dust, moisture, steam, smoke, sunlight or heat.
Ensure that the intake vents do not recycle hot air from the exhaust vent.
When operating the projector in an enclosed space, ensure that the surrounding air temperature within the enclosure does not exceed operation
temperature while the projector is running, and the air intake and exhaust vents are unobstructed.
All enclosures should pass a certified thermal evaluation to ensure that the projector does not recycle exhaust air, as this may cause the device to
shutdown even if the enclosure temperature is with the acceptable operation temperature range.
Avoid installing at high temperature, insufficient cooling and heavy dust locations.
Keep your product away from fluorescent lamps (>1 Meter) to avoid malfunction caused by IR interference.
Avoid installing near an air conditioner duct or a subwoofer.
The projector should be installed as close to the power outlet as possible.
The power connection should be easily accessible, so that it can be disconnected in an emergency.
Please pay attention to projector installation with respect to other staging laser light equipment set-up. These systems can cause permanent
damage to the DMD imaging devices used in our projectors. This damage is not covered by our warranty.
When using projectors in environments with third party high power laser systems avoid direct laser beams pointing towards the projection lens.
This may cause incident light to converge into the optical engine and cause damage to the DLP DMD.
Before installation, make sure that the surface, ceiling or rigging that is to support the projector is capable of supporting the combined weight of
the projector and lens.
Backup safety chains or wires should always be used with ceiling mount installations.
When installing a ceiling mount, make sure the weight limit is not exceeded and the projector is firmly secured.
Rev A December 2021
page 16
Installation & QuickStart Guide
Notes
Содержание Digital Projection E-Vision 4000 Series
