LDB-1se User Manual
16
Set Functions
To use any of the Set Functions, follow these steps:
1.
Hold down the Set button. Do not release it until the setting process is finished. The top Row
LED is blinking fast. This tells you that you are expected to make a selection. The top row of
number LEDs will be illuminated to indicate which settings are available in the current mode.
2.
Press and release the number button associated with the desired setting/function.
3.
Press the appropriate number buttons to adjust the setting.
4.
Release the Set button.
To reiterate, you have to hold down the Set button the whole time.
Set Functions Available by Mode
Not every Set function is available in every mode. Refer to the table below. In general, pattern editing
functions are only available in pattern editing modes, not in play modes.
Solo
Mute
Swing
Rand
Time
Mods
Length
Clear
Bank
Pattern
/ Song
Save
Pattern Play
Fill Play
Overlay Play
Pad Play
Pad Record
Step Edit
Trigger Edit
Config Edit
Set: Solo / Mute
Solo and mute change which instruments are played without changing the patterns. The top LEDs indicate
which instruments are soloed, and the bottom LEDs indicate which instruments are muted.
Row
Switch between setting which instruments are soloed (top row) or muted (bottom row).
Num
Add or remove an instrument from the solo group or mute group.
Select
Turn solo/mute on or off. This is important. Changing the instruments in the solo/mute groups
does not immediately affect what is playing. You have to turn either solo or mute on for it to have an
effect. Press Select while the top Row LED is lit to turn solo on or off. Press Select while the bottom Row
LED is lit to turn mute on or off. Solo and mute cannot both be on at the same time. The top or bottom
Row LED blinks to indicate that solo or mute is on. If neither LED is blinking, then all instruments play
normally.
