Model 9320-150 Installation Instructions
Page 11 of 13
Document: RDS-INS9293V, Rev. C
Do not copy or distribute without written permission. Unpublished Work
2019 Delphi Display Systems, Inc. All rights reserved.
Printed copies are Uncontrolled unless clearly marked as a Controlled document. User is responsible for verifying document is the current revision.
lights may be visible on the transmitter without the power supply connected, failure to use the power
supply may prevent functionality. Always use the power supply.
5.3.1
V-Net Transmitter Detail
Figure 13 – V-Net Transmitter Detail
5.4
Connecting Power to the Display
Connect the 120VAC power cable to the power input connector on the rear panel of the display as shown
below. Verify that the power indicator lights up.
Figure 14 – Display Power Connection
Video output signal
connected via CAT5
cable to the display
VGA Input
Connector to be
connected to the
VGA output of the
video server
Aux VGA Onput
Connector can be
connected to a
local VGA monitor
to view the video
being transmitted
to the VNet display
RS232 Diagnostic
Connector. NOT
USED.
USB Diagnostic
Connector. NOT
USED.
+12VDC Power
Input to be
connected external
power supply
transformer
Power Indicator
VGA ACTIVE lit when VGA
signal present in VGA IN
connector
***WARNING***
Do not apply power to
the display until both
ends of the CAT5 cable
have been terminated
and connected.
Verify that the
power indicator
light is on when
power is applied
