Model 9320-150 Installation Instructions
Page 10 of 13
Document: RDS-INS9293V, Rev. C
Do not copy or distribute without written permission. Unpublished Work
2019 Delphi Display Systems, Inc. All rights reserved.
Printed copies are Uncontrolled unless clearly marked as a Controlled document. User is responsible for verifying document is the current revision.
Lastly, tighten the compression nut and the assembly is complete. The completed connector should look
like the one pictured below.
Figure 11 - Field Connector Assembly Step 5
The water-proof RJ45 connector is now ready for connection to the display. Plug the connector to the back
of the display at the RJ45 receptacle. Once connected, screw the “Connector Nut” into the back of the
display until it is tight. Refer to the figure below for an example of a proper connection.
Figure 12 – Connecting the RJ45 connector to the Display
5.3
V-Net Transmitter Installation
Route the CAT5 cable from where the display is mounted to the area where the video server or PC that will
be providing the VGA signal is located. The V-Net transmitter should be installed close to the video server,
preferably permanently mounted using provided mounting screws to minimize movement of the
transmitter device and potential damage to the attached cables. The transmitter should be within 3ft. or 1
meter of the video server and an available wall outlet (to supply power to the Transmitter). Terminate the
end of the Cat5e cable with a standard RJ45 connector wired exactly the same way as the other end was
done. Note: the power supply MUST be attached to the transmitter to insure functionality. Though some