9
pouring, and out of the lid or spout when refilling.
- Keep the kettle, the power base, and the mains lead away
from hotplates, hobs or burners.
- The
power cable must not be replaced by
the user as this requires the use of special
tools. If the supply cord is damaged, it
must be replaced by the manufacturer,
its service agent or similarly qualified
persons in order to avoid a hazard.
- If the kettle is overfilled, boiling water
may overflow.
- The heating element surface is subject to
residual heat after use.
Please note:
- Remove the kettle from its power base before filling.
- Never move the kettle while it is in use.
- Do not use the kettle for any purpose other than heating
water.
- De’Longhi will not accept any liability if the appliance is
subject to improper use, or failure to comply with these
instructions.
- Never use the kettle without its lid and filter.
- Position the kettle properly on the power base before
switching on.
-
Use the kettle only with the power base
supplied (and vice versa).
The appliance complies with the following EC directives:
- This appliance conforms to the Directive 2004/108/EC
relative to electromagnetic compatibility.
- Materials and accessories coming into contact with food
conform to EC regulation 1935/2004.
Disposing of the appliance
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.
DESCRIPTION
A
Removable filter
B
Removable lid
C
Kettle body
D
Power-on indicator lights
E
360° base with cord storage
F
Plug
G
ON/OFF switch
H
Water level indicator
USE
Before use
- Remove all packaging from the kettle and power base.
- Remove any labels from the outer stainless steel surfaces.
- Remove the filter (fig. 1) and wash with water (fig. 2).
Refer to “Removing the scale filter”.
- Fill the kettle and boil.
- The boiled water should be discarded and the kettle rinsed
out with cold water. This procedure should be carried out
three times, to remove any manufacturing dust, etc.
- After the kettle has been rinsed out, re-fit the filter (fig. 3).
In use
With the specially designed power base and central connector,
you can now set the kettle on the base at any angle, from any
position.
- Release cord from storage base
and adjust length by winding
around the base to give the
correct cord length to reach the
plug socket to be used (fig. 4).
- Do not leave loose cord hanging
over the edge of work surfaces.
Filling
- Remove the kettle from the base unit before filling.
- Open lid and fill kettle to desired level.
3
2
1
4
