4) Undo the right hand screw on the cable
clip. (Fig. 6)
5) Disconnect the electrical connector by
pushing the tabs
B
, then pulling out the
connector (fig. 7)
6) Remove the safety plug (fig. 8).
7) Open the locking lever on the quick-fit
coupling. To facilitate closing, use the
extension
, fitting it onto the lever and
turning until fully open (see figure 9).
24
8) Disconnect the male and female cou-
plings by pushing the sleeve backwards
and pulling (Fig. 10).
To avoid damage to the couplings, before
passing the sheath through the hole in the
wall, you should protect the ends of the
quick-fit coupling using the caps provided or
with paper tape (Fig. 11).
22
Make sure the connecting sheath is free of
kinks.
Important
Always disconnect or connect the quick-fit
couplings in the open air or adequately ven-
tilated rooms.
Pre p a r i n g f o r u s e
fig. 8
fig. 6
1
B
2
fig. 7
fig. 9
1
2
fig. 10
fig. 11
