8
Tempory installation
Note:
In both cases (permanent and temporary installations) make sure that the Pinguino is posi-
tioned on level ground. If necessary, use the two caster stops for the front casters
This installation makes it easy to
use Pinguino in any room, provi-
ded there is a window or a door: it
allows you to use the Pinguino
immediately (Fig. 5).
Suction cups may be used to
keep window or door closed (Fig.
6).
Pinguino is equipped with an adju-
stable window bracket. If you have
a sliding window, place the bracket
on the window sill, extend the
bracket fully within the window
frame and lower the window onto
the bracket. Insert the nozzle of the
exhaust hose into the slot, then con-
nect the hose to the air conditioner
(Fig. 7). With the wing nut, it’s possi-
ble to use the window bracket also
for sliding windows. Position the hole
of the bracket so to allow a correct
installation of the exhaust hose (see
the following instructions).
PREPARING THE UNIT FOR USE
1) Fit the exhaust tube in place; if your conditioner is
supplied with a extendable tube, it is fitted as illu-
strated in the diagram.
2) For permanent installation, place the appliance
near the wall or window outlet. Make sure it is stan-
ding on a level surface and fit the special shock
absorbers/castor stops underneath the castors.
1) Water collects at this point
2) Bend this section
3) Bend this section
NO
YES
YES
ELECTRICAL CONNECTION
Check that the power supply voltage is 115 V ~ 60 Hz.
Important:
If you need to use an extension cord, please be sure to
use a
heavy duty
extension cord (minimum 14 gauge).
Before connecting the Pinguino to a power supply, make sure
that all switches on the front control panel are in the OFF position.
Connect power cord found in storage compartment at rear of
the Pinguino (Fig. 9).
fig. 5
fig. 6
fig. 7
fig. 8
fig. 9
window
bracket
pac360U OK GB 24-04-2003 16:32 Pagina 8
