11
MODELS WITH ELECTRONIC TIMER
1. Set the cooking time by pressing the button (I). The minutes set appear on the display (H).
2. Immediately afterwards, the numbers begin to flash. This means the cooking time has begun.
The last minute is displayed in seconds.
3. If you make a mistake, you can set the new cooking time by holding the button down for more than two
seconds.
When the display has reset, repeat the operation.
4. The timer indicates the end of cooking time with two series of “beeps” separated by a 20 second gap.To
turn off the signal, just press the timer button (I).
If the appliance is to be replaced or thrown away, the battery must be removed and disposed of in accor-
dance with current laws as it represents an environmental hazard.
IMPORTANT: the timer does not turn the appliance off
MODELS FITTED WITH OIL DRAIN TAP
CAUTION! To avoid getting burnt do not drain oil when
oil is hot.
Proceed as follows:
1. Remove the basket.
2. Open the cover (J).
3. Open the tap (K) by turning it anticlockwise.
4. Run the liquid into a container (see the figure below),
making sure it doesn’t overflow.
5. Remove any deposits form the bowl using a sponge or
tissue paper.
6. Close the tap by turning it clockwise.
7. Close the cover (J).
It is a good idea to keep the oil used to fry fish sepa-
rate from that used to fry other food.
If lard or fat is used, make sure it does not cool down
too much, otherwise it will solidify.
CLEANING
Before cleaning, make sure that the power plug is disconnected.
Never immerse the deep fryer in water and never place it under running tap water (see Fig. 7). The infiltration of
water into the control unit may cause electrocution. Check that the oil has cooled down, and then remove the con-
trol unit and drain the oil. Remove the deposits from the bowl using a sponge or absorbent paper.
Except for the control unit, power cable and heating element, all the other parts can be cleaned with warm water
and dishwashing detergent (see Fig. 8). Never use abrasive sponges, to avoid damaging the deep fryer.
When this procedure has been completed, carefully dry all parts, to prevent hot oil from spraying out during
operation.
Important information for correct disposal of the product in accordance with EC Directive 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this
service.
Disposing of a household appliance separately avoids possible negative consequences for the environment
and health deriving from inappropriate disposal and enables the constituent materials to be recovered to
obtain significant savings in energy and resources.As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out wheeled dustbin.
