14
3. Lower the spouts as near as possible to the
cup. This makes a creamier coffee (fig. 10).
4. Press the corresponding coffee button (1 cup
or 2 cups ) (fig. 7 and 11).
5. Preparation begins. A progress bar appears
on the display and gradually advances as the
procedure progresses (fig. 12).
Once the coffee has been made, the appliance is
ready to use again.
NB!
•
While the machine is making coffee, delivery
can be interrupted at any moment by pressing
one of the coffee buttons ( or ).
•
As soon as delivery is finished, to increase the
quantity of coffee in the cup, just hold down
one of the coffee buttons ( or ) until
the required amount is reached (this must be
done within three seconds after completion of
delivery).
•
If the coffee is delivered in drops, too fast and
not creamy enough or too cold, read the tips
in the "Troubleshooting" section on page 21.
Making coffee using pre-ground
coffee
NB! If you use pre-ground coffee, you
can only make one cup of coffee at a time.
1. Press the button repeatedly (fig. 13)
until "READY Pre-Ground" is displayed and the
light flashes.
Important!
•
Never add pre-ground coffee when the machi-
ne is off or it could spread through the inside
of the machine and dirty it.
This could damage the appliance.
•
Never use more than one
level measure or it could
dirty the inside of the
machine or block the fun-
nel.
2. Put one level measure of pre-ground coffee
into the funnel (fig. 14).
3. Place a cup under the coffee spouts.
4. Press the 1 cup coffee button (fig. 7).
FROTHING THE MILK FOR
CAPPUCCINO (AND HEATING
LIQUIDS)
The steam can be used to froth milk and heat
liquids.
NB!
To make cappuccino, prepare the cof-
fee in a large cup then add the frothed milk.
Important!
Danger of burns
When you use the steam function, steam comes
out of the cappuccino maker. Take care to avoid
burns.
1. Turn the cappuccino maker outwards and
place a container underneath (fig. 3).
2. Press the button until the light comes
on.
NB!
To avoid residual water being mixed
with the milk during frothing, you should deliver
the water first. To do this, allow the water mixed
with the steam to flow for a few seconds until only
steam comes out.
3. Press the button (fig. 1). The appliance
heats up and "Please Wait..." is displayed.
When the appliance reaches the ideal tempe-
rature, it begins producing steam and
"Steam..." is displayed. Interrupt by pressing
the same button again.
4. Empty the container and fill with about 100
grams of milk for each cappuccino to be pre-
pared. In choosing the size of the container,
bear in mind that the milk doubles or triples in
volume.
You are recommended to use semi-skimmed
milk at refrigerator temperature.
5. If the cappuccino maker fitted to your model
has a double position ring, turn the ring* to
the CAPPUCCINO position (fig. 15). If on the
other hand you want hot milk, turn the ring to
the "MILK" position.
5. Immerse the cappuccino maker in the milk
container (fig. 16). Take care not to immerse
the black ring or the raised line on the cap-
puccino maker.
6. Press the button. Steam is discharged
from the cappuccino maker, giving the milk a
creamy frothy appearance.
