5
INTRODUCTION
Than you for choosing a De’Longhi product. Please ta e a few
moments to read the instructions to avoid ris s or damage to the
appliance.
DESCRIPTION
Description of the appliance (See page 3 - A)
A1
Air outlet flap
A2
Control panel
A3
Handles
A4
Wheels
A5
Remote control signal receiver
A6
Remote control storage
A7
Filter
A8
Air inta e grille
A9
Air exhaust hose housing
A10
Air inta e grille
A11
Drainage hose with cap
A12
Power supply cable
Description of accessories (See page 3 - B)
B1
Wall flange with cap
B2
Air exhaust hose
B3
Window outlet
B4
Window brac et with pins
B5
Additional window brac et with pins
B6
Water drain hose with cap
B7
Remote control
B8
End of season dust cover
B9
End of season accessories bag
Electrical connection
Before plugging the appliance into the outlet, chec that:
• The outlet’s power supply corresponds to the value
indicated on the rating label on the bac of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• The outlet is a 3-hole grounded outlet
. If this is not
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a qualified professional only.
The instructions below will enable you to prepare your air
conditioner for operation as e ciently as possible. Before use,
ma e sure the air inta e and outlet grilles are unobstructed.
USE
Note: This appliance features an auto evaporative
function to remove excess condensate water
during cooling and dehumidifiying modes.
CONDITIONING WITH INSTALLATION
For optimal results set-up your appliance in this way:
• Fit the assembled air exhaust hose
B2
in the housing at the
bac of the appliance. Insert it as shown in figure 1.
1
• Respect the distances given in figure 2.
2
min. 11.8 in
min. 30 cm
min. 11.8 in
min. 30 cm
Proceed as follows:
• Drill a hole 5,25 inches (134 mm) in an outside wall or
through a wooden ic board. Respect the dimensions and
height of the hole given in figure 3 and 4.