DeLonghi ECAM45.76 Series, Инструкция по эксплуатации

Страница: 24 / 27

23
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK Insufficient water in the tank (A16). Fill the tank with water and/or insert it cor-
rectly, pushing it as far as it will go until it
clicks into place.
EMPTY GROUNDS CONTAINER The grounds container (A10) is full. Empty the grounds container and drip tray
(A12), clean and replace (fig. 31). Important:
when removing the drip tray, the grounds
container (A10) MUST be emptied, even if it
contains few grounds. If this is not done, when
you make the next coffees, the grounds contai-
ner may fill up more than expected and clog the
machine. If the problem persists, make sure the
water tank (A16) is fully inserted, press the
button (B7) and deliver a little water from the
spout (C6).
GROUND TOO FINE ADJUST
MILL The grinding is too fine and the coffee is delive-
red too slowly or not at all. Repeat coffee delivery and turn the grin-
ding adjustment dial (A5, fig. 14) one click
clockwise towards “7” while the coffee mill is
in operation. If after making at least 2 coffees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
the section: “Adjusting the coffee mill” on page
13).
If the water softener filter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery. Insert the hot water spout (C6) in the appliance
and deliver a little water until the flow beco-
mes regular.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced (A10).
Remove the drip tray (A12) and insert the
grounds container.
ADD PRE-GROUND COFFEE With the “pre-ground coffee” function selected,
pre-ground coffee has not been poured into the
funnel (A4). Place pre-ground coffee in the funnel or dese-
lect the “pre-ground” function (fig. 18).
DESCALE The machine must be descaled. The descaling procedure described in the section
“Descaling” needs to be performed as soon as
possible (page 19).
REDUCE COFFEE AMOUNT Too much coffee has been used.
Select a milder taste by pressing the
button (B2- fig. 11) or reduce the quantity of
pre-ground coffee.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (fig. 15).
The pre-ground coffee funnel (A4) is clogged. Empty the funnel with the help of a brush (C5)
as described in the section “Cleaning the pre-
ground coffee funnel” (page 18).
INSERT INFUSER ASSEMBLY The infuser has not been replaced after clea-
ning (A15). Insert the infuser as described in the para-
graph “Cleaning the infuser” (page 18).