DeLonghi ECAM44.66X ELETTA, Инструкция по эксплуатации

Страница: 17 / 23

16
• Extract the drip tray (fig. 27), empty and clean.
• Empty the grounds container (A10) and clean thoroughly
to remove all residues left on the bottom. This can be done
with the spatula on the brush provided (D2).
• Check the condensate tray (A9) and empty if necessary (fig.
28).
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coffees, the grounds
container may fill up more than expected and clog the machine.
Cleaning the drip tray and condensate tray
Important!
The drip tray (A12) is fitted with a level indicator (red) showing
the level of water it contains (fig. 29).
Before the indicator protrudes from the cup tray, the drip tray
must be emptied and cleaned, otherwise the water may over-
flow the edge and damage the appliance, the surface it rests on
or the surrounding area.
To remove the drip tray:
1. Extract the drip tray (A12) and grounds container (fig. 27);
2. Empty the drip tray and grounds container (A10) and wash
them;
3. Check the condensate tray (A9) and empty if necessary;
4. Replace the drip tray complete with grounds container.
Cleaning the inside of the coffee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see “Turning off”) and unplugged from the mains power sup-
ply. Never immerse the coffee machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coffee deposits with the brush
supplied (D2) and a sponge.
2. Remove the residues with a vacuum cleaner (fig. 30).
Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month
and whenever you replace the water softener filter (if pres-
ent) with a damp cloth and a little mild washing up liquid.
2. Remove the filter (if present) and rinse with running water.
3. Replace the filter (if present), fill the tank with fresh water
and replace the tank.
Cleaning the coffee spouts
1. Clean the coffee spouts regularly with a sponge or cloth
(fig. 31).
2. Check the holes in the coffee spout are not blocked. If nec-
essary, remove coffee deposits with a toothpick (fig. 31).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel (A4) is not blocked.
If necessary, remove coffee deposits with the brush (D2)
supplied.
Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “Turning
off”, page 10).
2. Extract the water tank (fig. 4).
3. Open the infuser door (fig. 32) on the right side of the
appliance.
33
PUSH
4. Press the two red release
buttons inwards and at the
same time pull the infuser
outwards (fig. 33).
5. Soak the infuser in water for
about 5 minutes, then rinse
under the tap.
Important!
RINSE WITH WATER ONLY NO WASHING UP LIQUID - NO
DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (D2) to remove any coffee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 34), then push the PUSH symbol fully
in until it clicks into place.
34
Infuser
support