DeLonghi ECAM23.42X, Инструкция по эксплуатации

Страница: 16 / 22

15
12.2 Cleaning the machine’s internal circuit
If the appliance is not used for more than 3-4 days, before
using it again, we strongly recommend switching it on and
performing:
•
2/3 rinse cycles by pressing the button (B4);
• delivering hot water by turning the hot water/steam dial
(A20) to the
I position.
Please note :
After cleaning, it is normal for the grounds container (A13) to
contain water.
12.3 Cleaning the coffee grounds container
When “EMPTY GROUNDS CONTAINER” is displayed, the grounds
container must be emptied and cleaned. Until the grounds
container (A13) has been cleaned, the appliance continues to
display the message and coffee cannot be made.
To clean (with the machine on):
•
Remove the drip tray (A17 - fig. 23), empty and clean.
• Empty the grounds container (A13) and clean thoroughly
to remove all residues left on the bottom. This can be done
with the spatula on the brush (C5) provided.
• Check the red condensate tray (A14) and empty if
necessary.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coffees, the grounds
container may fill up more than expected and clog the machine.
12.4 Cleaning the drip tray and condensate tray
Important!
If the drip tray (A17) is not emptied regularly, the water could
overflow from the edge and seep inside or around the machine.
This could damage the machine, the surface it rests on or the
surrounding area.
The drip tray is fitted with a level indicator (A16) (red) show-
ing the level of water it contains (fig. 24). Before the indicator
protrudes from the cup tray, the drip tray must be emptied and
cleaned.
To remove the drip tray:
1. Remove the drip tray and the grounds container (A13) (fig.
23);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray (A14) and empty if necessary.
4. Replace the drip tray and grounds container.
12.5 Cleaning the inside of the coffee machine
Danger of electric shock!
Before cleaning the internal parts, the machine must be turned
off (see “7 Turning off”) and unplugged from the mains power
supply. Never immerse the coffee machine in water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray - A17)
is not dirty. If necessary, remove coffee deposits with a
sponge.
2. Remove all the residues with a vacuum cleaner (fig. 25).
12.6 Cleaning the water tank
1. Clean the water tank (A9) regularly (about once a month)
and whenever you replace the water softener filter (C4, if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the filter (if present) and rinse with running water;
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank;
4. (Models with water softener filter only) Deliver about 100
ml of hot water to reactivate the filter.
12.7 Cleaning the coffee spouts
1. Clean the coffee spouts (A12) with a sponge or cloth (fig.
26A).
2. Check that the holes in the coffee spouts are not blocked.
If necessary, remove coffee deposits with a toothpick (fig.
26B).
12.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground
coffee funnel (A6) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.
12.9 Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “7. Turn-
ing off”);
2. Remove the water tank (A9);
3. Open the infuser door (A10 - fig. 27) on the right side of the
appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 28);
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER