17
Please note
The filter lasts about two months if the appliance is used nor-
mally. If the coffee machine is left unused with the filter in-
stalled, it will last a maximum of three weeks.
3. To activate the filter, run tap water through the hole in the
filter as shown in the figure until water comes out of the
openings at the side for more than a minute (fig. 31A).
4. Extract the tank from the appliance and fill with water.
5. Insert the filter in the water tank and immerse it complete-
ly for about 30 seconds, turning it upside down to enable
the air bubbles to escape (fig. 31B).
6. Insert the filter in the filter housing (fig. 32A) and press as
far as it will go.
7. Close the tank with the lid (fig. 32B), then replace the tank
in the machine.
When you install the filter, you must notify the appliance of its
presence.
8. Press the
P
button to enter the menu;
9. Turn the selection dial until the
and
lights come
on.
10. Press the
button. The
OK
light flashes.
11. Press the
button to confirm the selection.
12. Place a container under the cappuccino maker (min. capac-
ity: 100 ml).
13. Turn the steam dial and press the
button.
14. After delivery, the
light flashes. Close the dial and the
appliance returns automatically to the “ready for coffee”
state.
The filter is now active and you can use the machine.
Replacing the filter
When the
light flashes, after two months (see date indica-
tor) or when the appliance has not been used for 3 weeks, you
should replace the filter:
1. Extract the tank and exhausted filter;
2. Take the new filter out of its packet and proceed as illus-
trated in points 3, 4, 5, 6 and 7 in the previous section.
3. Place a container (min. capacity: 100 ml) under the cap-
puccino maker.
4. Press the
P
button to enter the menu;
5. Turn the selection dial until the
and
lights come
on.
6. Press the
button. The
OK
light flashes.
7. Press the
button to confirm the selection.
8. Turn the steam dial and press the
button.
9. After delivery, the
light flashes. Close the dial and the
appliance returns automatically to the “ready for coffee”
state.
The new filter is now active and you can use the coffee machine.
Removing the filter
If you want to use the appliance without the filter, you must
remove it and notify the appliance of its removal. Proceed as
follows:
1. Extract the tank and exhausted filter;
2. Press the
P
per entrare nel menù;
3. Turn the selection dial (fig. 8) until the
and
lights
come on;
4. Press the
button. The
OK
light flashes;
5. Press the
button to confirm use of the appliance
without the filter;
6. Press the
button to exit the menu.
TECHNICAL DATA
Voltage:
220-240 V~ 50/60 Hz max. 10A
Absorbed power:
1450W
Pressure:
1,5 MPa (15 bar)
Max. water tank capacity:
1.8 litres
Size: LxHxD:
238x345x430 mm
Cord length:
1150 mm
Weight:
9.1 kg
Max. beans container capacity:
250 g
The appliance complies with the following EC
directives:
• Low Voltage Directive 2006/95/EC and subsequent
amendments;
• EMC Directive 2004/108/EC and subsequent amendments;
• European Standby Regulation 1275/2008
• Materials and accessories coming into contact with food
conform to European regulation 1935/2004.
DISPOSAL
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
