33
• Empty the grounds container (A13) and clean thoroughly
to remove all residues left on the bottom.
• Check the red condensate tray (A12) (fig. 23) and empty if
necessary.
19.4 Cleaning the drip tray and condensate tray
Important!
The drip tray (A14) is fitted with a level indicator (A16) (red)
showing the amount of water it contains (fig. 24). Before the
indicator protrudes from the cup tray (A17), the drip tray must
be emptied and cleaned otherwise the water may overflow the
edge and damage the appliance, the surface it rests on or the
surrounding area.
To remove the drip tray:
1. Remove the drip tray and grounds container (A13) (fig. 23);
2. Remove the cup tray (A17) and drip tray grille* (A15), then
empty the drip tray and grounds container and wash all
components;
3. Check the red condensate tray (A12) and empty if
necessary;
4. Replace the drip tray complete with grille* and grounds
container.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coffees, the grounds
container will fill up more than expected and clog the machine.
19.5 Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see section “8. Turning the appliance off”) and unplugged from
the mains power supply. Never immerse the machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray (A14)) is
not dirty. If necessary, remove coffee deposits with a brush
and a sponge;
2. Remove all the residues with a vacuum cleaner (fig. 25).
19.6 Cleaning the water tank
1. Clean the water tank (A7) regularly (about once a month)
and whenever you replace the water softener filter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the filter (C4) (if present) and rinse with running
water;
3. Replace the filter (if installed), fill the tank with fresh water
and replace;
4. (Models with water softener filter only) Deliver about
100ml of water.
19.7 Cleaning the coffee spouts
1. Clean the coffee spouts (A11) regularly with a sponge or
cloth (fig. 26A);
2. Check the holes in the coffee spouts are not blocked. If nec-
essary, remove coffee deposits with a toothpick (fig. 26B).
19.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground cof-
fee funnel (A4) is not blocked. If necessary, remove coffee depos-
its with a brush.
19.9 Cleaning the infuser
The infuser (A9) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see “8. Turn-
ing the appliance off”);
2. Remove the water tank (A7);
3. Open the infuser door (A8) (fig. 27) on the right side of the
appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (fig. 28);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISHWASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush to remove any coffee residues left in the in-
fuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support, then push the PUSH symbol fully in until it
clicks into place;
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers (fig. 29).
8. Once inserted, make sure the two coloured buttons have
snapped out;
9. Close the infuser door;
10. Put the water tank back.
20. DESCALING
Descale the appliance when the
light on the control panel
flashes.
Important!
