DeLonghi ECAM22.360, Инструкция по эксплуатации

Страница: 10 / 20

9
Connect the appliance to an efficiently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualified
professional.
Setting up the appliance
Please note :
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section “Setting water
hardness” on page 16.
1. Insert the power cable connector into the socket at the
back of the appliance and connect the appliance to the
mains electricity supply (fig. 1). Make sure the main switch
at the back of the appliance is pressed (fig. 2).
you must first choose the language (the languages scroll
through at intervals of about 3 seconds):
2. When English appears, press the
button (fig. 3)
for a few seconds until “ENGLISH set” is displayed.
Follow the instructions indicated on the appliance display:
3. “FILL TANK”: remove the water tank, fill to the MAX line
with fresh water (fig. 4A), then replace in the appliance
(fig. 4B).
4. “INSERT WATER SPOUT”: Check that the hot water spout is
inserted on the nozzle and place a container holding a mini-
mum of 100 ml underneath (fig. 5).
5. “HOT WATER Confirm?” appears on the display.
6. Press the
button to confirm. The appliance deliv-
ers water from the spout then goes off automatically.
The coffee machine is now ready for normal use.
Please note :
• When setting up the appliance, you need to make 4/5
cups of coffee or 4/5 cappuccinos before the appliance
starts to give satisfactory results.
TURNING THE APPLIANCE ON
Please note :
Before turning the appliance on, make sure the main switch on
the back of the appliance is pressed (fig. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath. Avoid contact with
splashes of water.
• To turn the appliance on, press the button (fig. 6).
The message “Heating up Please wait” is displayed.
After heating, the message “Rinsing” is displayed. As well as
heating the boiler, the appliance also heats the internal circuits
by circulating hot water.
The appliance is at temperature when the message “READy” is
displayed and the taste has been selected.
TURNING THE APPLIANCE OFF
Each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Danger of burns!
During rinsing, a little hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the button (fig. 6). The
appliance performs a rinse cycle then goes off (stand-by).
Please note:
If you will not be using the appliance for some time, unplug
from the mains socket:
• first turn the appliance off by pressing the
button
(fig. 6);
• press the main switch (fig. 2).
Important!
Never press the main switch while the appliance is on.
MENU SETTINGS
Press the
MENU
button to enter the settings menu.
Descaling
For instructions on descaling, see page 15.
Adjust time
To adjust the time on the display, proceed as follows:
1. Press the MENU bu tton to enter the menu;
2. Press the or button until “Adjust time” is dis-
played;
3. Press the button;
4. Press the or button to change the hour;
5. Press the button to confirm;
6. Press the or button to change the minutes;
7. Press the button to confirm.
The time is set: press
MENU
to exit menu.